Designing an irrigation system but is it really necessary?

We are often asked how to solve problems inherent in the malfunction of the systems, such as the sprinkler does not wet the lawn well, the sprinkler that does not do the meters it should do, the sprinkler does not get up but shit water, the pump does not go under pressure or you continue to turn on and off …. and so you ..

These problems often have one element in common, or melgio 99.0 % of the time, is the lack of proper design and therefore the lack of a general planning that avoids the problem before and not that it must be solved after the realization of the impinato.

For example, this video shows a project

The design "if done with knowledge", allows the identification of the pipes to be used, the correct subdivision of the zones based on the real resource of the water(see video of how to measure the dynamic flow)and the use of the correct sprinklers according to their characteristics.

On some occasions, however, it is also true that there may be other variables that alter the correct functioning and then it is necessary to understand if the culprit is the source of water, such as the change in water availability of the alda (if used by pump), wear of the pump, or the clogging of the sprinklers to which seasonal maintenance has not been done.

All things, which with the executive project in hand, can be analyzed and allow more easily the identification of the culprit.

We provide a design service to help you anticipate and prevent potential problems and start off on the right foot with your irrigation system.

It is always inconvenient, expensive and ugly to make an implant, spend money on materials and see that it does not work well.